Settings - ProMinent DULCOMETER Installation And Configuration Manual

7.2 SETTINGS

Factory Click on it to select the desired default setting:
default set‐
Custom (select sensors and outputs)
n
tings
Configuration 1 : CTFS conductivity Volume –
n
Bio A - Inhibitor
Configuration 2 : CTFS conductivity Volume –
n
Bio A – Inhibitor - ORP
Configuration 3 : CTFS conductivity Volume –
n
Bio A – Inhibitor - Chlorine
Configuration 4 : Volumetric mode Volume – Bio
n
A – Inhibitor
Configuration 5 : Resistive conductivity Volume
n
– Bio A – Inhibitor
Sensor list Select desired sensor configuration from predefined
configuration:
CTFS Sensor (SI1)
n
Temperature Sensor (RI1)
n
Conductivity Sensor (RI2)
n
Volume counter (DI1)
n
Flow-switch contact (DI2)
n
Output list Select desired output configuration from predefined
configuration:
Bleed valve (PO1) - is always selected.
n
Biocide A (FO1)
n
Biocide B (FO2)
n
Inhibitor (FO3)
n
Dispersant (FO4)
n
Fig. 63: Upload configurations
After the configuration of inputs and outputs in the setup menu,
detailed configurations like timers, setpoint and alarms can be
done in this menu.
General Menu
57