Table of Contents
Advertisement
NOTICE
Turning device screwed on the flywheel housing during engine operation!
Property damage - Risk of engine major failure.
u Dismount immediately the turning device and mount the cover on the flywheel housing.
Information
The wrench tool and the turning device are available for maintenance task only.
Should you have any queries, please contact your authorized Kohler service representative.
Installation
Fig. 115: Mounting the turning device
1
Screws (M16x35 -8.8)
2
Turning device
To mount the turning device:
u Unscrew screws 4.
u Remove cover 3.
u Position turning device 2.
u Mount and tighten screws 1 according to standard torque values.
Information
Should you have any queries, please contact your authorized Kohler service representative.
Operation
Make sure that the following preconditions are met:
q Turning device is mounted on the engine.
Depending on the required setting:
u Engage a manual wrench tool to turn the wheel from the turning device that drives the
flywheel gear rim.
u Turn the engine flywheel to the required position or as long needed by turning the wrench.
u Disengage the manual wrench each time you stop to turn.
KD62V12A 33521061401_1_1 EN_US
2023-10
3
4
© 2023 by Kohler Co. All rights reserved.
Tools and devices
Cover
Screws (M16x25 -8.8)
Tools
203
Advertisement
Table of Contents
