Table of Contents
Advertisement
5.3 Maintenance information
5.3.1 General information
Shorten the maintenance intervals according to the operating conditions, for example:
– Dusty environment
– Oil quality
– Fuel quality
Always make sure that lubricants, fuel, other liquids, and replaced parts are disposed of in a
safe and environmentally acceptable manner. The environmental regulations applicable in the
country of use must be adhered to.
5.3.2 Service level 0 — Monthly maintenance activities, TBO 4000 hours
for ESP — Engine Operation - Version: 2023/07-01
Component
SL0-1011
Engine (stopped)
SL0-1021
Engine (idle speed)
SL0-1022 Engine in operation
SL0-2011
Oil system
KD62V12A 33521061401_1_1 EN_US
2023-10
Service
Schedule
Type
Task is performed when engine is stopped.
Inspect engine overall condition.
Record and report any anomaly. For example:
-
1M
x
-
leak, damage, loose part, etc.
(→ 5.6.1 Inspecting engine overall condition —
SL0-1011, p. 105)
Observe engine running at idle.
Record and report any anomaly. For example:
leak, faulty parameter, unusual noise, unusual
-
1M
x
-
vibration, unusual exhaust gas color.
(→ 5.6.2 Inspecting engine running at idle
speed — SL0-1021, p. 123)
Perform test run at more than a 1/3 load (if
parameters are within range) and at least until
steady-state temperature is reached.
Record and report any anomaly. For example:
-
1M
x
-
leak, faulty parameter, unusual noise, unusual
vibration, unusual exhaust gas color, etc.
(→ 5.6.3 Testing engine in operation (ESP
application only) — SL0-1022, p. 123)
Task is performed when engine is stopped.
Check engine oil level. Fill up with oil if needed.
Check prelubricating oil pump operation at
-
1M
x
-
engine start (displayed pressure).
Take corrective action if defect is present.
(→ 5.7.1 Inspecting oil system overall condition
— SL0-2011, p. 138)
© 2023 by Kohler Co. All rights reserved.
Maintenance
Maintenance information
Task description
85
Advertisement
Table of Contents
