Kohler KD62V12A Operation And Maintenance Manual page 145

Removal
Fig. 76: Removing spin-on oil filters
1 Spin-on oil filter
2 Filter head
Information
Actual number of spin-on oil filters depends on engine configuration.
u Clean sealing area.
u Open spin-on oil filter 1 with filter ribbon spanner.
u Remove filter.
u Repeat procedure for all filters.
Installation
u Clean sealing area.
u Lubricate filter seal 3 with clean, fresh engine oil.
u Screw spin-on oil filter 1 in filter head 2 until it contacts base.
u Tighten filter by hand by 1/2 turn.
u Repeat procedure for all filters.
u Operate prelubricating pump to vent the filters. In the absence of prelubricating pump,
disconnect TDC sensor (on aggregate support) and crank the engine until oil pressure builds
up.
KD62V12A 33521061401_1_1 EN_US
2023-10
3
© 2023 by Kohler Co. All rights reserved.
2000 - Lubricating oil system
Seal
Maintenance
145