Table of Contents
Advertisement
MENU D_OUT
Press to Save Setting
Go Back to Parent Menu
Press and Hold to Go Back
The Tch2Pt, TchMid, AdjSPt1, and AdjSPt2
menus are only available in Wnd mode.
When in SPt, Alarm, or Health modes, these menus
are replaced by TchSPt and AdjSPt.
3.6.1. Two-Point TEACH
The TchSpt1 and TchSPt2 options teach the desired switch points. When using the buttons, the switch points can be taught independently. Both
values must be taught when using the remote input.
: When in Switch mode, see
NOTE
Navigate:MENU > D_OUT > Tch2Pt > TchSPt1 and navigate: MENU > D_OUT > Tch2Pt > TchSPt2
Remote Input: Available
Button Instructions
1)
Present the target.
Present the target. The target must be within the sensor's range..
2)
Access the TEACH mode and TEACH the sensor.
D_OUT Tch2Pt
D_OUT TchMid
Select Menu Item
or
D_OUT AdjSPt1
D_OUT AdjSPt2
or
D_OUT Mode
to Run Mode
D_OUT SPtRef
(in SPt mode only)
(in SPtRef Custom mode only)
D_OUT Offset
D_OUT Hyst
D_OUT Timer
D_OUT Polarity
Figure 9: Discrete Output Menu Map
TEACH Switch
Point.
Action
© Banner Engineering Corp. www.bannerengineering.com
Tch2Pt TchSPt1
TchSPt1 50mm
Tch2Pt TchSPt2
TchSPt2 12000mm
TchMid WndSize
WndSize +00020mm
TchMdPt 6000mm
TchMid TchMdPt
TchMid Offset
Offset 0mm
AdjSPt1 +00050mm
AdjSPt2 +12000mm
Mode Alarm
Mode Health
Mode Swtch
Mode Swtch
Mode Wnd
Mode Wnd
SPtRef Object
SPtRef Backgrnd
SPtRef Custom
Offset 0 mm
Hyst Auto
Timer OffDly
OffDly 0 ms
Timer Off1Sho
Off1Sho 0 ms
OnDly 0 ms
Timer OnDly
Timer On1Sho
On1Sho 0 ms
Polarity PNP
Polarity NPN
Result
The target's analog output measurement and distance
measurement value display.
S
P
ENSOR
ROGRAMMING
16
Advertisement
Table of Contents
