Banner LTF Series Instruction Manual page 20

S P
ENSOR ROGRAMMING
Navigate: MENU > D_OUT > Tch2Pt > TchSPt1
OR
Navigate: MENU > D_OUT > Tch2Pt > TchSPt2
3) Repeat steps 1 to 2 for the other switch point, if desired.
Remote Input Instructions
1) Access the TEACH mode.
Single-pulse the remote input.
2) Present the target.
Present the switch point one target.
3) TEACH the sensor.
Double-pulse the remote input.
4) Present the target.
Present the switch point two target.
5) TEACH the sensor.
Single-pulse the remote input.
17
Action
Action
Action
Action
T
Action
Action
© Banner Engineering Corp. www.bannerengineering.com
The selected TEACH mode and "Teaching" display
while the sensor is being taught.
TEACH Accepted
The new value is shown on the second line of the
display and flashes before it is saved and the sensor
returns to the parent menu.
TEACH Not Accepted
"FAIL" and a warning message display, and the
sensor returns to the parent menu.
"RMT TCH" and the current switch point value
T
displays.
"RMT TCH" and the target's measurement value
display.
"TchSPt1 Teaching" displays while the sensor is
being taught.
TEACH Accepted
The new value displays on the second line of the
T
display, flashes, and the sensor goes to "TchSPt2"
and the current measurement value.
T
TEACH Not Accepted
"FAIL" flashes, the sensor returns to step 2, and
"RMT TCH" displays.
"TchSPt2" and the target's measurement value
display.
"TchSPt2 Teaching" displays while the sensor is
being taught.
TEACH Accepted
The new value displays on the second line of the
T
display, flashes, and the sensor returns to Run mode.
TEACH Not Accepted
"FAIL" flashes, the sensor returns to step 2, and
"RMT TCH" displays.
Result
Result
Result
Result
Result
Result