Table of Contents
Advertisement
S
P
ENSOR
ROGRAMMING
Option
3.5 mA (0 V)
20.5 mA (10.5 V)
Hold
The Range advanced measurement behavior is affected by the Loss of Signal option. For additional information on advanced measurements,
see
26. The Range advanced measurement tracks a maximum and a minimum during the measurement period, and calculates
Trigger on page
the range as follows:
Range = maximum distance – minimum distance
If the maximum and/or minimum measurements are outside of the taught setpoints, the Loss of Signal option determines how the range is calcu-
lated.
Option
3.5 mA (0 V)
20.5 mA (10.5 V)
Hold
3.6. Discrete Output Menu (D_OUT)
Use this menu to view or change
•
Setpoints
•
Midpoint
•
Mode
•
Timers
•
Polarity
15
The Analog Output switches to this value 2 seconds after a loss of signal. When advanced measurements are enabled, the
Analog Output is updated to this value immediately upon the release of the trigger input. For Voltage models, this is 0 V.
(Default)
The Analog Output switches to this value 2 seconds after a loss of signal. When advanced measurements are enabled, the
Analog Output is updated to this value immediately upon the release of the trigger input. For Voltage models, this is 10.5 V.
The Analog Output holds the last value indefinitely during a loss of signal. When advanced measurements are enabled, the
last value is held across the triggered measurement periods.
If the maximum or minimum measurement is outside of the taught setpoints, the sensor outputs 3.5 mA (0 V) to indicate an
out of range measurement.
If the maximum or minimum measurement is outside of the taught setpoints, the sensor outputs 20.5 mA (10.5 V) to indicate
an out of range measurement.
The sensor limits the maximum and minimum measurements so that they cannot exceed the taught setpoints.
© Banner Engineering Corp. www.bannerengineering.com
Description
Sensor Behavior in Range Mode
Advertisement
Table of Contents
