Table of Contents
Advertisement
Default: 50 mm
3.6.4. Adjust Switch Point Two
The AdjSPt2 option manually adjusts the value of the switch point two threshold for the Discrete Output when the sensor is in Window mode.
The value is adjustable with the sensor's range. It is required to be maintain the minimum window size between switch points. This menu is not
available when the sensor is in Switch, Alarm, or Health mode.
Navigate: MENU > D_OUT > AdjSPt2
Remote Input: Not available
Default: 12000 mm for LTF12; 24000 mm for LTF24
3.6.5. TEACH Switch Point
The TchSPt option teaches the distance at which the switch point threshold is placed when the Discrete Output is in Switch mode. This menu is
not available when the sensor is in Window, Alarm, or Health mode.
Navigate: MENU > D_OUT > TchSPt
Remote Input: Available
Button Instructions
1)
Present the target.
Present the target. The target must be within the sensor's range.
2)
Access the switch point TEACH mode and TEACH the sensor.
Navigate: MENU > D_OUT > TchSPt
Remote Input Instructions
1)
Verify the sensor is in Switch mode.
2)
Access the TEACH mode.
Single-pulse the remote input.
3)
Present the target.
Present the target.
4)
TEACH the sensor.
Action
Action
Action
Action
© Banner Engineering Corp. www.bannerengineering.com
The target's analog output measurement and distance
measurement value display.
"TchSPt Teaching" displays while the sensor is being
taught.
TEACH Accepted
The new value is shown on the second line of the
display and flashes before it is saved and the sensor
returns to "D_OUT TchSPt".
TEACH Not Accepted
"FAIL" and a warning message display, and the
sensor returns to "D_OUT TchSPt".
"RMT TCH" and the current measurement value
T
display.
"RMT TCH" and the target's measurement value
display.
S
P
ENSOR
ROGRAMMING
Result
Result
Result
Result
20
Advertisement
Table of Contents
