Installing The Host Adapter; Connecting The Interface Cable; Connecting More Than One Lto Standalone Unit - ADIC LTO 200D User Manual

Unpacking and Inspecting
Unpack all items from the carton. Save the packing materials in case you need to move or ship the system in the future.

Installing the Host Adapter

At this point if your host computer system does not have native SCSI capability and the host adapter you are using is not installed, please
install it. Refer to the manual that came with your host adapter for specific directions.
When the host adapter card is installed, return to this point in the manual.

Connecting the Interface Cable

Attach an interface cable between the host adapter and the LTO standalone. The type of cable needed depends on the type of SCSI bus
connector on the host adapter. The LTO standalone has two SCSI device connectors on the rear panel. It does not matter which connector is
used.
Make sure that the SCSI cable between the host adapter and the LTO standalone is secure and the connections are fastened
correctly.

Connecting More than One LTO Standalone Unit

If connecting to more than one LTO standalone unit on the same SCSI bus, connect each unit to the previous unit with an interface cable.
The connection sequence between the units is not critical. Refer to Figure 2-1 on the following page to see a configuration setup.
10 Installation
If the operating environment differs from the storage environment by 15°C
(30°F) or more, let the unit acclimate to the surrounding environment for at
least 12 hours.
You must ship the LTO standalone in the original or equivalent packing
materials or your warranty may be invalidated.
The jackscrews at the ends of the SCSI cable must be securely
fastened to ensure communications between the LTO standalone
Don't forget to install the SCSI terminator on the last device in the
Caution
Caution
Note
and the host computer.
Note
chain.