Table of Contents
Advertisement
Installing the Backup Software
This is the software
í
that runs the VLS, not
the data being
transferred to the VLS
cartridges. Two
examples of backup
software are Cheyenne's
ARCserve and Legato's
NetWorker.
A display similar to the following will appear:
You are now ready to install the backup software – if it has
not already been installed.
At this point you need to refer to your software installation
guide for instructions on installing the backup/controlling
software for the VLS onto the host computer.
After you have completed installation of the VLS unit and of the
software, to make sure your unit is operating correctly, you
should run any diagnostic test(s) supplied with the backup
software.
Connecting the VLS
15
Advertisement
Table of Contents
