Pantum CP2500 Series User Manual page 131

Troubleshooting
•
Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
•
Update the network firmware in the printer or the print server. For more information, contact customer
support.
Non-Printer Manufacturer [color] [supply type], see User's Guide [33.xy]
Note: The supply type can be a toner cartridge or the imaging kit.
The printer has detected an unrecognized supply or part installed in the printer.
Your printer is designed to function best with genuine supplies and parts made by the printer manufacturer.
Use of third-party supplies or parts may affect the performance, reliability, or life of the printer and its imaging
components.
All life indicators are designed to function with supplies and parts, and may deliver unpredictable results if
third-party supplies or parts are used. Imaging component usage beyond the intended life may damage
your printer or its associated components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage.
Damage caused by the use of third-party supplies or parts may not be covered by the warranty.
To accept any and all of these risks, and to proceed with the use of non-genuine supplies or parts in your
printer, press and
If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and
then install a genuine supply or part.
Note: For a list of supported supplies, visit our Web site or contact the place where you purchased the
printer.
Paper too short [34]
Try one or more of the following:
•
Load the correct size of paper in the tray.
•
From the printer control panel, press
•
Check the tray length and width guides and make sure the paper is loaded properly in the tray.
•
Make sure the correct paper size and type are specified in Print Properties or in the Print dialog.
•
Make sure the paper size and type settings are specified in the Paper menu on the printer control panel.
•
Make sure the paper size is correctly set. For example, if the Multipurpose Feeder Size is set to
Universal, then make sure the paper is large enough for the data being printed.
•
Cancel the print job.
Printer had to restart. Last job may be incomplete.
From the printer control panel, press
For more information, go to our Web site or contact the place where you purchased the printer.
simultaneously for 15 seconds to clear the message and continue printing.
to clear the message and print using a different tray.
to clear the message and continue printing.
131