Pantum CP2500 Series User Manual page 59

Understanding printer menus
Use
Recycled
Paper
Card Stock
Transparency
Glossy
Rough/Cotton
Labels
Envelope
Universal Setup menu
Use
Units of Measure
Inches
Millimeters
Portrait Width
3–14.17 inches
76–360 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge
To
Specify a paper type when Recycled is selected.
Notes:
•
Paper is the factory default setting.
•
The Recycled paper type must be supported in the selected tray or
feeder in order to print from that source.
To
Identify the units of measure.
Notes:
•
Inches is the U.S. factory default setting.
•
Millimeters is the international factory default setting.
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
8.5 inches is the U.S. factory default setting. You can increase
the width in 0.01‑inch increments.
•
216 mm is the international factory default setting. You can
increase the width in 1‑mm increments.
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
14 inches is the U.S. factory default setting. You can increase the
height in 0.01‑inch increments.
•
356 mm is the international factory default setting. You can
increase the height in 1‑mm increments.
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
59