Correcting The Print Position Of The Tray - Oki COREFIDO B822dn User Manual

Correcting the print position of the tray

You can correct the print start position vertically and horizontally on paper for each tray. Set the correction
volume in increments of 0.25 mm on the operator panel.
[X Adjust] and [Y Adjust] correct the simplex printing and the back side (the printing side fed from the tray) of
duplex printing.
[Duplex X Adjust] and [Duplex Y Adjust] correct the face side (the printing side fed from the duplex unit) of
duplex printing.
 The thick arrows in the figure indicate the paper feed direction.
 X indicates the vertical direction of paper travel, and Y the horizontal direction of paper travel.
 Correct with [+] to widen the blank space in the X direction, and [+] to widen the blank space in the Y direction.
 Readjustment might be necessary depending on the usage conditions (temperature and humidity/media type).
 This function corrects the position and does not improve the writing start position (±2mm).
1
Check that "Ready To Print" appears on the display.
If the machine is in the power saving mode, press «OK» to restore.
2
Press the scroll button ▼ on the operator panel several times to select [Menus], and press
«OK».
3
Press ▼ several times to select [Print Adjust], and then press «OK».
4
Check that [Print Position Adjust] has been selected, and then press «OK».
5
Press ▲ or ▼ to select the tray to correct, and then press «OK».
6
Press ▲ or ▼ to select the item to correct.
7
Press «OK».
8
Press ▲ or ▼ to select the correction volume, and press «OK». Check that [*] is displayed to the
left of the selected setting.
9
Press «CANCEL» to return to the standby screen.
- 201 -
Printing from a PC