Choosing A Valid Default Gateway - Oki COREFIDO B822dn User Manual

15
When "Connection successful." is displayed, the connection to the wireless LAN access point is
completed.
16
Go to "
6. Checking the connection from a PC
 When "Not connected to wireless access point" is displayed, repeat the procedure from Step 4.
 If you cannot connect, see
 For segment-based communication with a wireless LAN (infrastructure), refer to
gateway(P.61)".

5. Choosing a valid default gateway

By default, [Enabling Default Gateway] is set to [Wired(LAN1)]. This machine can use a wired LAN and
wireless LAN at the same time, but only either of them can be used to connect a terminal outside the segment
(a different subnet).
When a wireless LAN (infrastructure) is used to communicate across segments, follow the following procedure
to change into [Wireless(Infrastructure)].
1
Check that "Ready To Print" appears on the display.
If the machine is in the power saving mode, press «OK» to restore.
2
Press the scroll button ▼ on the operator panel several times to select [Admin Setup], and then
press «OK».
3
Press ▲ or ▼ to input the admin password, and press «OK».
Admin Password(P.207)
4
Check that [Network Setup] is selected, and press «OK».
(P.62)".
"Troubleshooting for wireless LAN
Preparing and connecting this machine to your PC
connection(P.414)".
- 61 -
"5. Choosing a valid default