Table of Contents
Advertisement
VITC FIELDS
Vitc fields off
Vitc field on
VITC SYMBOLS
Vitc symbols off
Vitc symbols on
BYPASS MODE
Bypass mode off
Bypass mode on
3.4.
PROGRAMMING THE ENGINEERING SETUP FUNCTIONS
DISPLAY LEVEL
Display Level = 2
OPERATION
Model 8950-SID Digital Source ID Decoder Manual
Select Vitc frames off to hide the timecode frames.
Select Vitc frames on to show the timecode frames.
The VITC FIELDS menu item is used to select whether the fields will be
shown when the time is displayed in the character inserter.
Select Vitc fields off to hide the timecode fields.
Select Vitc fields on to show the timecode fields.
The VITC SYMBOLS menu item is used to select whether the T and U
symbols will be shown in front of the time and user bit displays of the VITC.
Select Vitc symbols off to hide the symbols.
Select Vitc symbols on to show the symbols.
3.3.6. Turning on the SDI Video Bypass
The BYPASS MODE menu item is used to select whether the video
bypass relay will be active or not. This allows the user to manually put the
8950-SID in Bypass mode.
connected to the output, and the encoder will no longer be active.
Select Bypass mode off to turn off the Bypass relay and process the
incoming video through the source ID decoder.
Select Bypass mode on to activate the video bypass relay and disable the
decoder.
The Engineering Setup Menu is used to set the serial port baud
parameters, front panel display brightness, reset the 8950-SID to factory
defaults, etc. The Engineering Setup menu items are normally required
only during installation. See section 3.2.1 for information on using the
Engineering Setup menu system.
3.4.1. Adjusting the Front Panel Display Brightness
The DISPLAY LEVEL menu item is used to adjust brightness of the front
panel display. Use the ! and "keys to adjust.
Revision 1.0
In this mode, the input video is directly
Page 3-8
Advertisement
Table of Contents
