Table of Contents
Advertisement
7800 MultiFrame Manual
7737/7837CD2 Dual Composite Decoder
5.
ON SCREEN MENUS
5.1.
NAVIGATING THE ON SCREEN MENU SYSTEM
A rotary encoder allows card edge navigation on a set of On-Screen menus used to configure the module.
On-Screen menus are available only on the MON OUT BNC for the 7837CD2 series of modules. This
ensures that On-Screen menus are not accidentally put on-air.
To enter the On-Screen menu system, press the pushbutton once. This will bring you to the main setup
menu where you can use the rotary knob to move up and down the list of available sub-menus. An arrow
(>) moves up and down the left hand side of the menu items to indicate which item you are currently
choosing. Once the arrow is on the desired item, press the pushbutton to select the next menu level.
On all menus, there are two extra selectable items: Back and Exit. Selecting Back will take you to the
previous menu (the one that was used to get into the current menu) while Exit will return the display to its
normal operating mode. On the main menu, BACK and EXIT will both take you to the normal operating
mode.
Once in a sub-menu, there may be another menu layer, or there may be a list of parameters to adjust. If
there is another set of menu options, use the toggle switch to select the desired menu item and press the
pushbutton.
To adjust any parameter, use the rotary knob to move up or down to the desired parameter and press the
pushbutton. The arrow will move to the right hand side of the line (<) indicating that you can now adjust
the parameter. Using the rotary knob, adjust the parameter to its desired value. If the parameter is a
numerical value, the number will increase or decrease by turning the rotay knob left or right. If the
parameter contains a list of options, you can cycle through the list in the same fasion.
When you have stopped at the desired value, depress the pushbutton. This will update the parameter to
the selected value and move the arrow back to the left side of the parameter list (>). Continue selecting
and adjusting other parameters or use the BACK or EXIT commands.
Page - 10
Revision 1.0
Advertisement
Table of Contents
