Table of Contents
Advertisement
7700 Multi-Frame Manual
7707EO-3G 3G/HD/SDI Re-Clocking Electrical to Optical Converter
Toggle
Switch
4.2.1. Displaying the Video Rate
The card-edge display of the 7707EO-3G can report the signal rate present at the active video input. To
indicate the input video rate, select STAT (Status) menu item in menu level 1, followed by RATE (Video
Rate) menu items.
STAT
RATE
2970
1485
270
BYP
LOS
Page-10
Menu Level 1
Menu Level 2
Indications
LASR...ERR (Laser Error)
Supersedes
LOS (Video Loss)
Supersedes
OK (Okay)
Selections
Selections
RATE (Signal Rate)
STAT (Status)
VER (Software Version)
BACK (Abort)
Selections
RATE (Signal Rate)
LASR (Laser Mode)
CTRL (Control)
GPO (GPO Settings)
DISP (Display Orientation)
FRST(Factory Reset)
BACK (Abort)
Figure 4-2: 7707EO-3G Card-edge Menu Quick Reference
The following list describes the available selections.
SMPTE 424M: 2.97Gb/s 3G.
2970
SMPTE 305M: 1.485Gb/s HD.
1485
SMPTE 259M C: 270Mb/s 525i or 625i, DVB-ASI.
270
Indicates reclocker is in non-reclock mode.
BYP
Indicates that no valid input signal is present.
LOS
Pushbutton
Menu Level 3
Indications
2970 (2970Mbps Rate)
1485 (1495Mbps Rate)
270 (270Mbps Rate)
BYP (Reclocker Bypass)
LOS (Loss of Signal)
Indications
Software Version
Indications
AUTO (Auto Rate / Bypass)
2970 (2970Mbps Rate)
1485 (1495Mbps Rate)
270 (270Mbps Rate)
BYP (Reclocker Bypass)
Selections
CONT (Continuous)
DISC (Discontinuous)
Selections
LOS (Loss of Signal)
LASR (Laser Error)
Selections
POL (GPO Polarity)
Selections
HORZ (Horizontal)
VERT (Vertical)
Selections
NO (Abort)
YES (Accept)
Revision 1.1
Menu Level 4
Selections
EN (Enable Trigger)
DIS (Disable Trigger)
Selections
OPEN (Normally Open)
CLOS (Normally Close)
Advertisement
Table of Contents
