Controlling The Cursor Attributes; Controlling The Cursor White Level; Controlling The Cursor Size; Controlling The Cursor Position (Cursor Not Centred) - evertz 9590 Instruction Manual

Models 9590 & HD9590 Graticule Generator Manual

3.6.3. Controlling the Cursor Attributes

When the cursor object is selected the CTRL SEL button is used to select which of its attributes (white
level, position, or size) will be adjusted by turning the shaft encoder knobs. Press the CTRL SEL button
until the desired CTRL SEL item is shown on the front panel. When you have chosen the desired CTRL
SEL item press the CURSOR button again or turn one of the shaft encoder knobs to begin controlling the
selected attribute of the cursor.

3.6.3.1. Controlling the Cursor White Level

Level The white level can be adjusted in the range of "0" through "14", in single digit increments,
using either shaft encoder with "0" corresponding to "black" and "14" corresponding to "white".

3.6.3.2. Controlling the Cursor Size

Size The size of the cursor can be adjusted using either of the shaft encoders. The size will change
proportionately about the centre of the cursor.
H/V Size The left shaft encoder is used to adjust the height of the CURSOR vertical line, and the right
shaft encoder is used to adjust the width of the cursor horizontal line.

3.6.3.3. Controlling the Cursor Position (Cursor not centred)

Mode menu Centre
When the cursor centring is Off the position of the cursor can be adjusted.
Position The left shaft encoder is used to adjust the vertical position of the cursor, i.e. move the cursor
up or down and the right shaft encoder is used to adjust the horizontal position of the cursor,
i.e. move the cursor left or right.

3.7. CONTROLLING THE BOX OBJECTS

There are two box objects, called box1 and box2.
independently, and operate the same way. Often box1 is used to mark the safe action area and box2 is
used to mark the safe title area. References throughout this section to the box object apply to either box1
or box2.

3.7.1. Turning the Box Objects On and Off

To turn on the box1 object press the BOX
blink item on the Setup menu is enabled), and the box1 object will be turned on. The LED above the
BOX button will come on indicating that the box1 object is selected. To turn off the box1 object, press
the ON/OFF button when it is selected. To turn on the box2 object press the BOX
time. The box2 object will blink momentarily (if the obj blink item on the Setup menu is enabled), and the
box2 object will be turned on. To turn off the box2 object, press the ON/OFF button when it is selected.
Page 3-18
off
button. The box1 object will blink momentarily (if the obj
Each of the box objects can be controlled
RACK MOUNT PANEL OPERATION
button a second