Table of Contents
Advertisement
Part II – Invoke upload mode via the front panel
5.4.2.2.
8. HD9590: If you are using the integrated control panel or the rack mount control panel, press the
ON/OFF, 4 and 9 buttons simultaneously. If you are using the desktop remote control panel press the
ESC and GRID buttons simultaneously. The control panel display should now show the current
firmware version of the unit. To proceed with the upgrade turn one of the shaft encoder knobs
clockwise (to the right) and you will see the message UPLOAD:Setup=yes
9590: If you are using the integrated control panel or the rack mount control panel, press the ON/OFF,
4 and 9 buttons simultaneously. If you are using the desktop remote control panel press the ESC and
GRID buttons simultaneously.
UPLOAD:Setup=yes
9. Press the SETUP button to confirm the Upgrade operation.
10. You should now see a prompt on the terminal program screen asking you to upload the file.
For example:
UPLOAD FILE FOR $08000 NOW, CONTROL-X TO CANCEL
11. Skip to step17.
If you cannot invoke the upload mode via the front panel outlined in Part II then follow
the steps in Part III.
Part III – Invoke upload mode via the terminal program
5.4.2.3.
12. While the cursor is spinning press the <CTRL> and <X> keys on your computer keyboard at the same
time, this should stop the cursor from spinning. If the Graticule Generator continues to boot-up, simply
cycle the power on the Graticule Generator and repeat this step.
13. Hit the <ENTER> key on your computer once.
14. Type the word "upgrade", without quotes, and hit the <ENTER> key once.
15. The boot code will ask for confirmation. Type "y", without quotes.
16. You should now see a prompt asking you to upload the file.
For example:
BOOT> upgrade
UPLOAD FLASH MAIN
ARE YOU SURE YOU WANT TO UPLOAD FLASH? [Y/N] Y
UPLOAD FILE FOR $08000 NOW, CONTROL-X TO CANCEL
TECHNICAL DESCRIPTION
Models 9590 & HD9590 Graticule Generator Manual
The control panel display should now show the message
Page 5-5
Advertisement
Table of Contents
