Controlling The Cursor White Level; Controlling The Cursor Size; Controlling The Cursor Position (Objects Not Centred, Aspect Ratio Off); Controlling The Box Objects - evertz 9590 Instruction Manual

Models 9590 & HD9590 Graticule Generator Manual

4.6.3. Controlling the Cursor White Level

Press the LEVEL button to adjust the cursor white level. The white level can be adjusted in the range of
"0" through "14", in single digit increments, using either shaft encoder with "0" corresponding to "black" and
"14" corresponding to "white".

4.6.3.1. Controlling the Cursor Size

Press the SIZE button, when the cursor its button is blinking, to adjust the cursor size. The shaft encoders
are used to adjust the size of the cursor. The remote panel display will show the cursor size while the
SIZE button is brightly illuminated. The size adjust function will be deselected after 3 minutes of panel
activity, or when the another button is pressed.

4.6.3.2. Controlling the Cursor Position (Objects not centred, Aspect Ratio Off)

Press the POS button while the cursor button is blinking to control the position of the cursor. When auto
aspect ratio mode is Off and the Setup menu Force Centre item is set to no the left shaft encoder is used
to adjust the vertical position of the cursor, i.e. move the cursor up or down, and the right shaft encoder is
used to adjust the horizontal position of the cursor, i.e. move the cursor left or right. The remote panel
display will show the cursor position while the POS button is brightly illuminated. The position adjust
function will be deselected after 3 minutes of panel activity, or when the another button is pressed.

4.7. CONTROLLING THE BOX OBJECTS

There are two box objects, called box1 and box2. Each of the box objects can be controlled
independently, and operate the same way. Often box1 is used to mark the safe action area and box2 is
used to mark the safe title area. References throughout this section to the box object apply to either box1
or box2.

4.7.1. Turning the Box Objects On and Off

To turn on the box1 object press the BOX1 button. The box1 object will blink momentarily (if the obj
blink item on the Setup menu is enabled), and the box1 object will be turned on. The BOX1 button will
blink indicating that the box1 object is selected. To turn off the box1 object, press the BOX1 button
when it is blinking. To turn on the box2 object press the BOX2 button. The box2 object will blink
momentarily (if the obj blink item on the Setup menu is enabled), and the box2 object will be turned on.
The BOX2 button will blink indicating that the box2 object is selected. To turn off the box2 object,
press the BOX2 button when it is blinking.
Page 4-16 DESKTOP REMOTE OPERATION