Controlling The Box Size And Position (Box Not Centred, Aspect Ratio On); Controlling The Circle Object; Turning The Circle Object On And Off; Controlling The Circle Modes - evertz 9590 Instruction Manual

Size The left shaft encoder is used to adjust the height of the box, and the right shaft encoder is
used to adjust the width of the box about the centre of the box.
Position The left shaft encoder is used to adjust the vertical position of the box, i.e. move the box up or
down, and the right shaft encoder is used to adjust the horizontal position of the box, i.e. move
the box left or right.
H no track The left shaft encoder is used to adjust the left side of the box and the right shaft encoder is
used to adjust the right side of the box.
V no track The left shaft encoder is used to adjust the top of the box and the right shaft encoder is used to
adjust the bottom of the box.

3.7.3.5. Controlling the Box Size and Position (Box not centred, Aspect Ratio On)

Setup menu Force centre
Mode menu Aspect ratio
Mode menu Centre
When the box centring is Off and aspect ratio mode is On the position and overall size of the box can be
adjusted proportionately about the centre of the box based upon the aspect ratio selected.
Position The left shaft encoder is used to adjust the vertical position of the box, i.e. move the box up or
down and the right shaft encoder is used to adjust the horizontal position of the box, i.e. move
the box left or right.
Size The left shaft encoder is used to adjust the size of the box with the bottom right corner fixed.
The right shaft encoder is used to adjust the size of the box with the top left corner fixed.

3.8. CONTROLLING THE CIRCLE OBJECT

3.8.1. Turning the Circle Object On and Off

To turn on the circle object press the CIRCLE
blink item on the Setup menu is enabled), and the circle will be turned on. The LED above the CIRCLE
button will come on indicating that the circle object is selected. To turn off the circle object, press the
ON/OFF button when the LED above the CIRCLE button is illuminated.

3.8.2. Controlling the Circle Modes

When the circle object is selected, the MODE button is used to control its modes, such as aspect ratio,
and whether it is centred or not. Press the MODE button until the desired mode item is shown on the front
panel, along with the current setting. To select one of the other choices for that mode item, turn one of the
shaft encoders knobs. When you have chosen the desired setting for the mode item press the MODE
button again to save the new setting and view the next mode item. Continue pressing the MODE key until
RACK MOUNT PANEL OPERATION
Models 9590 & HD9590 Graticule Generator Manual
No
1:1 4:3 14:9 16:9
off
button. The circle object will blink momentarily (if the obj
1.67:1 1.85:1 2.35:1
Page 3-21