Table of Contents
Advertisement
2.
INSTALLATION
2.1.
REAR PANEL
The following sections describe the purpose of the rear panel connectors of the 9590 and HD9590.
Sections 2.1.1 to2.1.4 describe the specific signals that should be connected to the units.
2.1.1. Digital Video Connections (9590)
SDI INPUT
Input BNC connector for 10-bit serial digital video signals, compatible with the
SMPTE 259M-C standard. See section 5.1.3 for specifications of standard definition video
formats supported.
SDI PROGRAM OUT is the main serial digital video output. There are two BNC connectors which output
identical program video in serial component, compatible with the SMPTE 259M-C standard.
2.1.2. Digital Video Connections (HD9590)
HD PROG INPUT
Input BNC connector for 10-bit serial digital video signals, compatible with the
SMPTE 292M standard. See section 5.1.1 for specifications of high definition video formats
supported.
HD PROGRAM OUT is the main serial digital video output. There are four BNC connectors which output
identical program video in serial component, compatible with the SMPTE 292M standard.
2.1.3. Remote Control Connections
COM1
A 9 pin female 'D' connector for the RS-232 serial interface used for updating the firmware. On
older units where the Connector is located beside the power connector, it is labelled SERIAL
REMOTE.
INSTALLATION
Models 9590 & HD9590 Graticule Generator Manual
Figure 2-1: Model 9590 Rear Panel Layout
Figure 2-2: Model HD9590 Rear Panel Layout
Revision 1.4
Page 2-1
Advertisement
Table of Contents
