Part Iv - Uploading The New Firmware; Part V - Completing The Upgrade - evertz 9590 Instruction Manual

Models 9590 & HD9590 Graticule Generator Manual
5.4.2.4. Part IV – Uploading the new firmware
17. Upload the "*.bin" file supplied using the X-Modem transfer protocol of your terminal program.
18. The boot code will indicate whether the operation was successful upon completion of the upload.
For Example:
UPLOAD OKAY
BOOT>
19. The following is a list of possible reasons for a failed upload:
•
If you get the message "transfer cancelled by remote" you must restart the terminal program and load
the bin file using the method outlined in Part III – Invoke upload mode via the terminal program.
•
The supplied "*.bin" file is corrupt.
•
Wrong file specified to be uploaded.
•
The PCs' RS-232 communications port can't handle a port speed of 57600.
•
Noise induced into the RS-232 "straight-thru" serial extension cable.
Part V – Completing the Upgrade
5.4.2.5.
20. If you invoked the upload mode from the front panel, the Graticule Generator will automatically reboot
after a short timeout. If you invoked the upload mode from the terminal program, type the word "boot",
without quotes, and hit the <ENTER> key once. The Graticule Generator should now reboot.
21. If the Graticule Generator fails to reboot after the upgrade, then cycle the power on Graticule
Generator.
22. You can now close the terminal program and disconnect the RS-232 serial cable.
The update procedure is now completed
Page 5-6 TECHNICAL DESCRIPTION