Table of Contents
Advertisement
Models 9590 & HD9590 Graticule Generator Manual
4.3.4. Controlling the Object White Level
Press the LEVEL button to control the white level of the selected object (the one with its button blinking).
The white level can be adjusted in the range of "0" through "14", in single digit increments, using either
shaft encoder with "0" corresponding to "black" and "14" corresponding to "white". The level adjust
function will be deselected after 3 minutes of panel activity, or when the another button is pressed.
4.3.5. Remote Panel Display when Controlling the Objects
When an object is selected the name of the selected object will appear on the display. After a 3-second
timeout, the display will show the current value of the object parameters. If all of the parameters cannot
be displayed at the same time, the display will cycle through the parameters.
When the object is turned off by pressing its button again while it is blinking, the display will show that the
object is turned off. If the object is subsequently turned on, the display will indicate that it is on, then will
show the object parameters after a 3-second timeout.
When object attributes are being modified by turning one of the shaft encoders, the attribute being
controlled is displayed along with its current value. If there are more parameters to be displayed, the
display will cycle through the remaining parameters after a 3-second timeout.
4.4. CONTROLLING THE GRID OBJECT
The grid object consists of two horizontal lines and two vertical lines that intersect the horizontal lines.
4.4.1. Turning the Grid Object On and Off
To turn on the grid object press the GRID
button. The grid object will blink momentarily (if the obj blink
item on the setup menu is enabled), and the grid will be turned on. The GRID
button will blink
indicating that the grid object is selected. To turn off the grid object, press the GRID
button when it is
blinking.
4.4.2. Centring the Grid on the Raster
When auto aspect ratio mode is On the grid object will always be centred on the raster. When auto aspect
ratio mode is Off the SETUP menu item force centre controls whether the grid will be centred or not (see
section 4.2.9 for more information about auto aspect ratio mode). When the force centre item is Off it is
possible to independently position and size the grid, using the SIZE and POS buttons and turning one of
the shaft encoders as outlined in the following sections.
4.4.2.1. Controlling the Grid White Level
Press the LEVEL button to adjust the grid white level. The white level can be adjusted in the range of "0"
through "14", in single digit increments, using either shaft encoder with "0" corresponding to "black" and
"14" corresponding to "white".
Page 4-12
DESKTOP REMOTE OPERATION
Advertisement
Table of Contents
