The Preset Group; Shaft Encoders (Knobs) - evertz 9590 Instruction Manual

4.1.3. The Preset Group

This button group consists of the FACT PRESET, PRESET SAVE and SHIFT LOCK buttons and the
adjacent five numbered buttons. The actions of this button group allow you to save and recall various
setups for the Graticule Generator.
FACT PRESET This button is used to recall the factory presets. Press this button to recall the
factory presets that was previously selected. Turn one of the shaft encoder knobs to cycle
through the available factory presets. The name of the selected preset will be shown on the
front panel display, and the selected collection of object settings will be loaded into the
Graticule Generator. The FACT PRESET button will brightly illuminate when one of the factory
presets is loaded. See section 4.9 for more information about factory presets.
PRESET SAVE This button allows the user to save the current object settings to one of the ten user
preset memory locations. Each of the user preset memory locations can be individually
write-protected.
presets.
User presets cannot be deleted directly from memory they can only be overwritten
by another configuration saved to the same memory location.
SHIFT LOCK The state of the SHIFT LOCK button determines whether user preset locations 0 to 4 or 5 to
9 will be selected with the USER PRESET buttons. Press the SHIFT LOCK button to
toggle the shift lock function on or off. Shift lock is On when the SHIFT LOCK button is
brightly illuminated. See section 4.8.2 for a complete description of how to use the user
presets.
USER PRESETS These five buttons used in conjunction with the SHIFT LOCK button are used to store or
recall the nonvolatile USER PRESETS.
corresponding button once. See section 4.8.2 for a complete description of how to use the
user presets.

4.1.4. Shaft Encoders (Knobs)

The shaft encoders' function is to change the value of one or more of the current object's parameters
based on the current control option. When the auto aspect mode or setup menus are enabled the shaft
encoders are used to select menu options.
When the size or position of an object is being controlled, the left knob controls horizontal movements, and
the right knob controls vertical movements. Horizontal move operations will be to the right for clockwise
changes and to the left for counterclockwise changes. Vertical move operations will be down for clockwise
changes and up for counterclockwise changes.
DESKTOP REMOTE OPERATION
Models 9590 & HD9590 Graticule Generator Manual
See section 4.10 for a complete description of how to use the user
To recall a USER PRESET press the
Page 4-3