Controlling The Grid Size; Controlling The Grid Size (Objects Centred Or Aspect Ratio Mode On); Controlling The Grid Size And Position (Objects Not Centred, Aspect Ratio Off); Controlling The Mask Object - evertz 9590 Instruction Manual

4.4.3. Controlling the Grid Size

Press the SIZE button, when the grid button is blinking, to adjust the grid size. The size of the grid can be
adjusted in one of two modes, depending on the setting of the Setup menu Force Centre item and the
Auto aspect ratio mode. The remote panel display will show the grid size while the SIZE button is brightly
illuminated. The size adjust function will be deselected after 3 minutes of panel activity, or when the
another button is pressed.

4.4.3.1. Controlling the Grid Size (Objects centred or Aspect Ratio mode On)

Setup menu
Or
Auto Aspect ratio
When Force Centre is On or auto aspect ratio mode is On, the left shaft encoder is used to adjust the
height and the right shaft encoder is used to adjust the width about the centre of the raster when the SIZE
button is selected.
4.4.3.2. Controlling the Grid Size and Position
(Objects not centred, Aspect Ratio Off)
Setup menu
Auto Aspect ratio
When Force Centre is Off and, and auto aspect ratio mode is Off the left shaft encoder is used to adjust
the top of the grid and the right shaft encoder is used to adjust the bottom of the grid when the POS button
is selected. The left shaft encoder is used to adjust the left side of the grid and the right shaft encoder is
used to adjust the right side of the grid when the SIZE button is selected.

4.5. CONTROLLING THE MASK OBJECT

The mask object consists of a horizontal masked area at the top and bottom of the raster, and a vertical
masked area at the left and right side of the raster. The Setup Mask Start menu item controls the first line
in the vertical that will be blanked by the mask object.
Throughout the remainder of section 4.4.2 the mask dimensions refer to the boundaries between the
masked and unmasked area.

4.5.1. Turning the Mask Object On and Off

To turn on the mask object press the MASK
blink momentarily (if the obj blink item on the setup menu is enabled), and the mask will be turned on. The
MASK button will blink indicating that the mask object is selected. To turn off the mask object, press
the MASK button when it is blinking.
DESKTOP REMOTE OPERATION
Models 9590 & HD9590 Graticule Generator Manual
Force centre Yes
1:1 4:3 14:9 16:9
Force centre no
off
1.67 1.85 2.35
See section 4.2.7 for further information.
button. A dashed line at the edge of the mask object will
Page 4-13