Table of Contents
Advertisement
Models 9590 & HD9590 Graticule Generator Manual
you see the message Mode Select Off. The shaft encoders revert to controlling the selected control
for the object.
3.8.2.1. Centring the Circle on the Raster
Centre:
H + V
This item is used to control whether the circle object is centred on the raster or not. The centre item is
only available when the SETUP menu item force centre is set to off.
Select yes to force the circle object to be centred on the raster.
Select off to allow the circle object to be moved off centre.
independently position each line on the circle, or to position and size the whole circle, depending on the
settings of the aspect ratio MODE item and what CTRL SEL item is chosen.
3.8.2.2. Controlling the Aspect Ratio of the Circle
Aspect ratio
Off
This item is used to control whether the circle object shape is constrained to a specific aspect ratio, or
whether its horizontal and vertical dimensions can be independently controlled.
Select Off to allow the circle object's horizontal and vertical dimensions to be independently controlled.
Select one of the specific aspect ratios to constrain the horizontal and vertical dimensions so that the
aspect ratio of the circle object is maintained.
3.8.3. Controlling the Circle Attributes
When the circle object is selected the CTRL SEL button is used to select which of its attributes (white
level, position, size, or individual axes of the circle) will be adjusted by turning the shaft encoder knobs.
Press the CTRL SEL button until the desired CTRL SEL item is shown on the front panel. When you have
chosen the desired CTRL SEL item press the CIRCLE
knobs to begin controlling the selected attribute of the circle.
The items that will be shown in the circle CTRL SEL menu depend on the MODE settings and the settings
in the SETUP menu. In the sections describing the CTRL SEL items, the relevant settings from the circle
MODE and SETUP menus are shown where necessary.
3.8.3.1. Controlling the Circle White Level
Level
The circle white level can be adjusted in the range of "0" through "14", in single digit
increments, using either shaft encoder with "0" corresponding to "black" and "14" corresponding
to "white".
Page 3-22
Off
1:1
4:3
14:9
In this MODE the it is possible to
16:9
1.67:1
button again or turn one of the shaft encoder
RACK MOUNT PANEL OPERATION
1.85:1
2.35:1
Advertisement
Table of Contents
