Table of Contents
Advertisement
4.1.9. COM Port
Standard:
RS-232
Baud Rate:
57,600
Connector:
9 pin female "D"
4.1.10. General Purpose Inputs
Number of Inputs:
7
Function:
Preset select (4), Future use (3)
Type:
Opto-isolated, active low with internal pull-ups to externally supplied voltage
Connector:
Female DB-9
Signal Level:
closure to ground
4.1.11. Upconverter Processing
Internal paths between functional blocks:
Mathematical coefficients: 12 bits
Internal processing: Up to 36 bits
Output modes:
16:9 anamorphic stretch, 4:3 with side panels, 16:9 letterbox zoom to full size and
14:9 letterbox zoom to full size 14:9 with side panels.
Motion detection:
field/frame/mixed
Processing delay:
3 msec to 1 Frame, dependent on reference and output phasing
Filtering:
Independent H and V filters
4.1.12. Electrical
Voltage:
Autoranging 100 - 240 Volts AC, 50/60 Hz
Fuse Rating: 250 V, 1amp time delay
Power:
30 VA
Safety:
ETL Listed, complies with EU safety directives
EMI/RFI:
Complies with FCC Part 15 Class A regulations
Complies with EU EMC directive
4.1.13. Physical
Dimensions: 19" W x 1.75" H x 18.75" D.
(483mm W x 45mm H x 477mm D)
Weight:
8 lbs. (3.5Kg)
4.2.
UPGRADING FIRMWARE – CURRENT VERSIONS
The firmware in the HD9510UC Upconverter is contained on a FLASH EPROM. From time to time
firmware updates will be provided to add additional features to the unit. To confirm that you have the
current version of the upconverter see the rear panel drawing Figure 2-2. See section 4.3 for information
on upgrading firmware in early versions of the upconverter.
You will need the following equipment in order to update the Upconverter Firmware
TECHNICAL DESCRIPTION
HD9510UC High Definition Upconverter Manual
12 bits
Revision 1.1.1
Page 4-3
Advertisement
Table of Contents
