Uploading The New Firmware - evertz HD9510UC Instruction Manual

For example:
EVERTZ MFC5407 MONITOR 2.1.3
COPYRIGHT 1997, 1998, 1999, 2000, 2001 EVERTZ MICROSYSTEMS LTD.
COLD BOOT |
8. The following is a list of possible reasons for failed communications:
•
Defective Serial Upgrade cable.
•
Wrong communications port selected in the terminal program.
•
Improper port settings in the terminal program.
HyperTerminal will not change port settings while connected.
"Disconnect" Button then click the "Reconnect" button to activate changes to the port settings.
9. Hit the <ENTER> key on your computer once.
10. Type the word "upgrade", without quotes, and hit the <ENTER> key once.
11. The boot code will ask for confirmation. Type "y", without quotes.
12. You should now see a prompt asking you to upload the file.

4.2.4. Uploading the new firmware

14. Upload the "*.bin" file supplied using the X-Modem transfer protocol of your terminal program. If you
do not start the upload within 10 minutes the unit's Boot code will time out. You can restart the
upgrade process by power cycling the unit.
15. The boot code will indicate whether the operation was successful upon completion of the upload.
For Example:
UPLOAD OKAY
MFC5407 WARM BOOT> |
16. The following is a list of possible reasons for a failed upload:
•
If you get the message "transfer cancelled by remote" you must restart the terminal program and
load the bin file, then remove and install the module again.
•
The supplied "*.bin" file is corrupt.
•
Wrong file specified to be uploaded.
•
Wrong file transfer protocol used – make sure you specify Xmodem, not Xmodem 1K.
•
The PCs' RS-232 communications port can't handle a port speed of 57600.
•
Noise induced into the Serial Upgrade cable.
TECHNICAL DESCRIPTION
HD9510UC High Definition Upconverter Manual
(Refer to step 4 for settings).
Revision 1.1.1
Note that
Click on HyperTerminal's
Page 4-5