Reprogramming The Microcontroller In The Upconverter - evertz HD9510UC Instruction Manual

HD9510UC High Definition Upconverter Manual
4.3.3.4.

Reprogramming the Microcontroller in the Upconverter

First erase the MCU in the Upconverter by pressing the ERASE button and selecting all three sections by
clicking on them individually. (WINISP has a bug which causes the SELECT ALL button to not function
correctly and the erase function will hang the program)
Then press the ERASE button and a message will appear indicating how long the erase function will take.
This is a worst case timing and you should not be alarmed if the erase function is much quicker than
indicated. Typical erase times are in the order of ten to fifteen seconds. After erasing you should verify
the erase with a BLANK CHECK. The status display on the screen should say "The selected range is
Blank."
If all goes well, press the LOAD FILE button. You will be presented with a standard Windows file picker
dialog box that allows you to select the HD9510UC hex file and load it into WINISP's internal buffer.
Then press the PROGRAM PART button and the new software will be downloaded into the unit.
TECHNICAL DESCRIPTION Page 4-9
Revision 1.1.1