evertz HD9510UC Instruction Manual page 23

OUTPUT FORMAT
OUTPUT ASPECT
MOTION DETECTION
H/V FILTER
AUDIO EMBEDDER
TEST GENERATOR
4:3 POSITION
SIDE PANEL COLOUR
LINE 21 BLANKING
OUTPUT DELAY
REFERENCE SIGNAL
GENLOCK V PHASE
GENLOCK H PHASE
PRESETS
H BLANK START
H BLANK END
V BLANK START
V BLANK END
H POSITION
V POSITION
H SIZE
V SIZE
OUTPUT H POS
OUTPUT V POS
FIRMWARE VERSION
To enter the on-screen menu system, press the SETUP key. This will bring you to the main Setup menu
where you can use the ↑ & ↓ keys to move up and down the list of available sub menus. Top-level menu
items are shown in UPPERCASE. To adjust any parameter, use the ↑ & ↓ keys to move up or down to
the desired parameter. To view the possible values for that item, press the SELECT key. The current
value for that parameter will be shown blinking. Pressing the ↑ & ↓ keys allows you to show the possible
INSTALLATION
HD9510UC High Definition Upconverter Manual
Sets up the output video format.
Selects the aspect ratio format of the input video.
Selects the type of motion compensation algorithm that will be used in the
upconversion process.
Sets the sharpness of the filters
Enable or disable the audio deembedder.
Enable or disable the colour bar generator.
Sets the position of the image in 4:3 side panel mode
Sets the colour of the side panels in 4:3 side panel mode
Selects whether line 21 captions are blanked or upconverted
Sets the delay for the upconverter (video in referenced)
Selects the timing reference for the output
Sets the vertical phase of the output with respect to the genlock
Sets the horizontal phase of the output with respect to the genlock
Used to save and recall user presets
Sets the right side panel width
Sets the left side panel width
Sets the bottom letter box panel height
Sets the top letter box panel height
Sets the left side of the standard definition image that will be upconverted
Sets the top of the standard definition image that will be upconverted
Sets the horizontal size (width) of the standard definition image that will be
upconverted
Sets the vertical size (height) of the standard definition image that will be
upconverted
Sets the horizontal position of the upconverted image on the high definition
raster
Sets the vertical position of the upconverted image on the high definition
raster
Displays the firmware version of the Upconverter
Revision 1.1.1
Page 3-3