Setting The Upconverter Reference (Not On Early Versions); Setting The Timing Of The Output Video With Respect To The Gen Lock Input (Not On Early Versions) - evertz HD9510UC Instruction Manual

OUTPUT DELAY
Minimum
Frame

3.3.11. Setting the Upconverter Reference (Not on early versions)

The REFERENCE SIGNAL menu allows the user to choose the type of reference that will be used for the
output video. Early versions that do not have a gen lock reference are always references to the input
video and do not have this menu item.
REFERENCE
SIGNAL
Video In
Tri-level
NTSC
3.3.12. Setting the Timing of the Output Video with Respect to the Gen Lock Input
(Not on early versions)
The GENLOCK V PHASE and GENLOCK H PHASE menus allows the user to adjust the timing of the
output video when the REFERENCE SIGNAL is set to Tri-Level or NTSC. These menu items are not
available on early versions that do not have a gen lock reference.
GENLOCK V
PHASE
V Phase = xx
The V Phase and H Phase parameters allow you to control the timing of the output video with respect to
the beginning of the frame on the Gen Lock reference input. An internally generated digital video sync
structure, locked to the analog genlock reference signal (0
or 0 time of line 4 field 1 for NTSC references) is used to genlock the upconverter. The EAV of line 1 of
H
this digital reference sync is the point to which all the reference phasing adjustments are made. Figure
3-4 and Figure 3-5 show the relationship of the analog tri-level and NTSC inputs to the digital reference
sync frame when the V Phase and H Phase parameters are set to zero.
INSTALLATION
HD9510UC High Definition Upconverter Manual
When the Delay is set to minimum the output video will be delayed by the
minimum amount.
When the Delay is set to Frame, the output will be delayed 1 frame from the
input video.
When set to Video In the output video will be referenced to the input video. The
OUTPUT DELAY menu item selects whether the output video is one frame
delayed or a minimal delay
When set to Tri-level the output video will be referenced to an HD Tri-level sync
signal connected to the Reference BNC loop. Tri-level sync should be of the
same frame format as the output video format of the upconverter.
GENLOCK V PHASE and GENLOCK H PHASE menu items adjust the timing of
the output with respect to the Tri-level sync reference.
When set to NTSC the output video will be referenced to a NTSC composite
sync or black burst signal connected to the Reference BNC loop.
GENLOCK V PHASE and GENLOCK H PHASE menu items adjust the timing of
the output with respect to the NTSC reference.
When the REFERENCE SIGNAL menu is set to Tri-level or NTSC the timing of
the output video can be adjusted.
Revision 1.1.1
time of line 1 field 1 for HD Tri-level references
H
The
The
Page 3-9