Table of Contents
Advertisement
2.
INSTALLATION
2.1.
REAR PANEL
There are two versions of the HD9510UC. The rear panel of the early version is shown in Figure 2-1 and
the rear panel of the current version is shown in Figure 2-2.
Figure 2-2: HD9510UC Rear Panel Layout – Current version
Sections 2.1.1 to 2.1.5 describe the purpose of the rear panel connectors of the main Upconverter
sections and the specific signals that should be connected to the HD9510UC HD Upconverter. Sections
2.1.6 and 2.1.7 describe the purpose of the rear panel connectors and the specific signals that should be
connected to the optional composite decoder section of the UpConverter.
2.1.1. Standard Definition Digital Video Connections
SDI IN
This BNC connector is for connecting 10-bit serial digital video signals, compatible with the
SMPTE 259M standard.
SDI OUT This BNC connector contains a reclocked copy of the input video.
2.1.2. High Definition Digital Video Connections
HD OUT
There are four BNC output connectors containing the upconverted 10-bit serial digital video
signals, compatible with the SMPTE 292M standard. If the Audio embedder option is enabled,
these outputs will contain the group 1 audio present on the SDI input and delayed to match the
output video timing.
2.1.3. High Definition Reference Video Connections (Not on Early Version)
HD REF LOOP
is a high impedance loop through for connecting an analog video or tri-level sync
reference.
reference being used.
INSTALLATION
HD9510UC High Definition Upconverter Manual
Figure 2-1: HD9510UC Rear Panel Layout – Early version
The REFERENCE SIGNAL menu is used to select the correct type of video
Revision 1.1.1
Page 2-1
Advertisement
Table of Contents
