Table of Contents
Advertisement
6
To select a video signal assigned to a cross-point button
By selecting the key source bus with an auxiliary bus control block AUX
delegation button, and pressing the cross-point button, it is possible to select
the video signal assigned to the cross-point button.
(If you press the cross-point button with holding down [KEY], the key signal
assigned to the cross-point button.)
Note
In the above operation, the following settings must have been made.
• Assigning the key source bus to an AUX delegation button
• Setting the [KEY] button operating mode
Carrying out a color mix for key fill
When [Matte] is selected for key fill, you can combine color 1 and color 2. For
the combination, you can use not only a key wipe generator pattern, but also
the dedicated pattern for key edge color mix.
1
348
Key Setting Operations Using Menus
(See "Cross-Point Settings (Xpt Assign Menu)" in Chapter 16
(Volume 2).)
Split: You can select a key source signal independently of the key source
automatically selected in Auto Select mode.
When [Split] was selected in step 5, hold down the [SPLIT] button in the
key control block, then in the cross-point control block key 1 row, select
the key source signal. Alternatively, hold down the key delegation button
in the transition control block and press a cross-point button in the key 1
row to select the key source signal.
Notes
• In the above-stated key 1 row operation, you can only select a key signal
assigned to a cross-point button. For the method of selecting a video
signal, see "To select a video signal assigned to a cross-point button"
below.
• When [Split] is selected, the key memory function (see page 53) is
disabled.
For details, see "Auxiliary Bus Control Block Settings (Aux Assign Menu)"
in Chapter 16 (Volume 2).
For details, see "Operation Settings (Operation Menu)" in Chapter 16
(Volume 2).
In the <Key Fill> group of the Type menu, select [Matte] and press [Matte
Adjust].
Advertisement
Table of Contents
