Table of Contents
Advertisement
• Matrix Size: Assign the switcher matrix of each switcher processor to S-Bus
• External Box: To obtain the signal selection status of external devices with
• Alias Name Gp: Set the group number for an S-Bus description name to be
Tally interface setup (Tally)
Group tally settings (Group Tally)
• Tally Group: Select the group tally (Gp1 to 4 or Gp5 to 8) which can be
• S-Bus Tally Enable: Specify S-Bus tally enabled or disabled.
Wiring information input (Wiring)
Input the information which specifies the physical wiring between switcher
and routing switcher or between two routing switchers.
These settings are common to the parallel tally and serial tally.
Tally enable settings (Tally Enable)
Specify the destination to be the reference for tally generation, and make
various settings.
These settings are common to the parallel tally and serial tally.
• Tally Type: Specify the tally type.
• Destination: Specify the address and level.
• Tally Enable: Specify the timing at which a tally is enabled.
Copy (Tally Copy)
Copy the tally information pertaining to a particular source to a different
source.
These settings are common to the parallel tally and serial tally.
Parallel port settings (Parallel Tally)
Make the parallel port settings for output of tally information pertaining to
sources and destinations.
For each of the tally output terminal numbers, specify the tally type, and source
address or destination level and address.
184
Setup
space, and select the matrix size and positioning level, source address
settings, and so on.
a parallel input, assign a matrix as an external selector in the S-Bus space.
Make the matrix size, assignment level, source address, and other settings.
displayed in the source name displays for a cross-point operation.
used. (For the parallel tally, all groups can be used regardless of this setting.)
Enable: Always enabled.
Disable: Always disabled.
Tally Input: Follow the tally input status.
Advertisement
Table of Contents
