Table of Contents
Advertisement
3
4
Selecting a frame memory folder
Press a button in the frame memory folder selection area (see page 438).
By pressing [More] to switch the display, you can select from a maximum of
12 folders.
Thumbnails of the files within the selected folder appear.
Capturing an Input Image (Freeze)
Freezing an image and writing it to memory
To freeze the signal selected as input material, and write it to memory, use the
following procedure.
1
2
3
440
Still Image Operations
To the right of the target FM selection buttons, the FM1 and FM2 output
status appears (see page 436).
If required, press [Pair], to select the FM operation mode (pair mode).
On: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) as a pair.
Off: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) individually.
For more details, see "Pair mode" (page 80).
Note
In the Pair Recombination menu, the [Pair] operation is not possible.
Press the target FM selection button [FM1] or [FM2] (see page 436) to
select the FM operations apply to.
When [Pair] is On: Whichever of FM1 and FM2 you press, the pair is
selected.
When [Pair] is Off: One of the targets must be selected. However, in the
Clip >Play menu you can also select both FM1 and FM2.
In the Frame Memory menu, select VF1 'Still' and HF2 'Freeze/Store.'
The Freeze/Store menu appears.
Select the target frame memory.
For the procedure, see "Selecting outputs (FM) and target frame
memory" (page 439).
To enable V/K mode, press [V/K Mode] turning it on.
Advertisement
Table of Contents
