Table of Contents
Advertisement
Key Setting Operations Using Menus
There are two ways of making key settings: either using menus, or using the
key control block.
This section describes basic procedures for making key settings using the
menus, taking the M/E-1 >Key1 menu as an example.
Operations in the Key menus are the same for all banks (M/E-1 to M/E-3 and
PGM/PST).
For details of the method of using the key control block, see "Key Setting
Operations With the Key Control Block" (page 366).
Key Setting Menus
The key setting menus for each bank (M/E-1 to M/E-3 and PGM/PST) are as
follows.
Bank
M/E-1
M/E-2
M/E-3
PGM/PST
Accessing a key setting menu
For example, to access the M/E-1 >Key1 menu, carry out any of the following
procedures.
• In the menu control block, select the top menu selection button [M/E 1], then
• In the M/E-1 bank transition control block, press the KEY1 next transition
• In the M/E-1 bank independent key transition control block, press the key
• In the key control block, press the M/E delegation button [M/E1], then press
Any of the above operations displays the M/E1 >Key1 menu.
Note that you can access the DSK menus by pressing the button for the
corresponding key in the downstream key control block twice in rapid
succession.
338
Key Setting Operations Using Menus
Keys set
Keys 1 to 4
Keys 1 to 4
Keys 1 to 4
Downstream keys 1 to 4
press VF1 'Key1.'
selection button twice in rapid succession.
delegation button [KEY1] twice in rapid succession.
the key delegation button [KEY1] twice in rapid succession.
Menus
M/E-1 >Key1 to 4
M/E-2 >Key1 to 4
M/E-3 >Key1 to 4
PGM/PST >DSK1 to 4
Advertisement
Table of Contents
