Vertical Summit80 Manual page 87

Vertical Summit80 & Summit800
Feature Description and Operation Manual
−
The Absent Supervisor timer,
−
The No answer timer,
−
The busy/no-answer Retry count,
−
The Interval time: Each member is called in turn at expiration of the interval timer.
4. Set the Member Attributes by entering:
−
Index number
−
Type: Station, Individual CO, CO group, loop or Transit-out code (access loop for
networking call).
−
The CO value: the supervisor can select a specific CO line or CO group for used to
call external members.
−
Dial number: The station or external party number.
5. Press the Save button to store the Conference Group configuration.
Operation
IPECS phone & LDP Phones
To assign a {GRP MONITOR} button
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + ―55‖ + [HOLD/SAVE]
To initiate a Conference Group call:
1. Lift the handset.
2. Dial ―68‖xxx, the Conference Group code and group number (xxx).
3. Enter the Conference group password, if assigned, members receive the Conference
Group call.
To enter a Conference Group call:
1. Answer the ringing call and receive recorded announcement, if assigned and recorded.
2. Dial ―1‖ to enter the conference or hang-up to reject the conference. For iPECS UCS clients,
use Accept or Deny when notified of the conference.
To monitor conference member status or delete members while in the conference:
1. Press the Monitor flex button, the state of the first member is displayed.
2. Press [VOL UP/VOL DOWN] button to display the state of other members.
3. Press the [DND] button to delete a participant from the conference.
To monitor the Group member conference status while Not in the conference:
1. Press the [TRANS/PGM] button.
2. Dial ―55‖, the Monitor Conference Group code.
3. Press [VOL UP/VOL DOWN] button to display the state of other members.
To add a non-member to the Group:
1. Press the [HOLD/SAVE] button to place the conference on hold.
2. Call the desired party.
3. Press the [CONF] button.
76
Issue 1.2