Table of Contents
Advertisement
Vertical Summit80 & Summit800
Feature Description and Operation Manual
SLT
To make a page,
1. Lift the handset.
2. Dial the desired paging code.
3. If assigned, after the Page Warning Tone, make announcement.
4. Replace the handset, to return to idle.
To queue for a page when busy tone is received:
1. Dial ―556‖, the Call Back code.
2. Replace the handset returning to idle.
Conditions
1. Stations, which are denied access to paging, will receive error tone when any Page
Access code is dialed.
2. Stations dialing a Page Code will be queued when any of the other Internal or External
Page zones are busy.
3. DTMF signals from stations are transmitted through the systems External Page port
after access.
4. If an iPECS IP or LDP Phone user attempts to page using the speakerphone, pre-
selection will be activated and the display shows "LIFT THE HANDSET TO PAGE".
5. Stations in DND or busy will not receive Page announcements.
6. Stations, which are not included in any Internal Page Zone, will not receive any page,
including All Call.
7. For external paging, an external amplifier and speaker(s) are required.
8. The systems External Control Contacts may be assigned to activate when External
Page is accessed. The contact can be used to activate the External page equipment.
9. A station is permitted only one Page Zone queue request at a time. If a station
attempts another Page Zone queue, only the later queue request is honored.
10. When a busy Page Zone becomes idle, the system will select the oldest page queue,
and signal the appropriate station. The signaled station will have an audible ring
indicating the queue callback. The audible ringing will be a distinctive signal. The All
Page Zone, while signaling a queued station, is considered busy. In addition, the All
Page Zone is considered busy when any page zone is active.
11. The queue recall is always in the tone ring mode regardless of the station's ICM
signaling mode.
12. The Call Back ring signals the station for 15 seconds, after which, the queue is
canceled and the next station in the queue is signaled.
13. If the waiting station is busy, and the Page zone becomes available the next idle
station in the Page Queue list is signaled and the busy waiting station is placed at the
bottom of Page Queue list. If there is no other available queued station in the Page
Queue, the Page Queue for the busy station is canceled.
14. When the waiting station goes to idle, and both a ―Page Queue‖ and ―CO Call back
Queue‖ exist, the Page Queue is given priority.
302
Issue 1.2
Advertisement
Table of Contents
