Bronpi Trebol Installation, Operating And Servicing Instruction page 40

10.5.2. STOVE IN OPERATION
Once certain smoke temperature has been reached, the hot air fan starts working.
Once the ignition phase has been finished properly, the stove enters into "Work"
mode which represents the normal operating mode (see drawing D10.29).
P1
13:00
MOD
P3
P1
13:00
PCLR
P3
the stove is turned off, it starts the final cleaning phase in which the pellet feeder stops and the smoke extractor and the tangential fan start
working at maximum speed. This cleaning phase will not stop until the stove reaches the appropriate cooling temperature (see drawings
D10.32 and D10.33). Meanwhile, the following screens will appear:
P1
P3
10.5.6. REIGNITION OF THE STOVE
Once the stove is turned off, it is not possible to reignite again until a safety time has elapsed and the stove is cold enough. If you try to ignite
the stove again and it is not cold enough, the display will show the information on drawing D10.34 but the stove will not ignite again until it is
cold enough. Then, it will turn on normally.
10.5.7. STOVE
SWITCHED OFF
Drawing D10.35 shows the
information of the display
when the stove is switched
off.
10.5.8. STOVE IN
ALARM STATE
When the stove has an alarm
state, the display will show
the following messages
(see drawings D10.36 and
D10.37).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
The display shows the time,
the working power and the
P2
room temperature.
10.5.3.
TEMPERATURE REACHES
THE TEMPERATURE FIXED
BY THE USER
P4 When the room temperature reaches the value fixed by the user or the smoke
temperature reaches a value too high, automatically, the stove starts working at a
lower power. The stove modulates. See drawing D10.30.
D10.30
10.5.4.
P2
During the normal operation of the stove, there are automatic cleanins of the burner
each time set by Bronpi.
This cleaning lasts 150 seconds and consists in cleaning the rests of pellet placed in
the burner in order to make easier the operation of the stove. When this happens, the
display will show the following messages (see drawing D10.31):
P4
10.5.5.
D10.31
In order to switch-off the stove, simply press key P1 during a few seconds. Once
P2
OFF
3 22
P4
D10.32
P1
REC
3:20
P3
P1
ALE
3 22
P3
P1
THE ROOM
BURNER CLEANING
SWITCHING OFF THE STOVE
P1
13:00
3 22
P3
P2 P1
P4
D10.34
P2 P1
P4
D10.36
39
13:00
3 20
P3 P4
P2
P4
D10.33
15:05
20
P3 P4
ER 12
3 22
P3 P4
TREBOL - MILA - MINERVA
P2
D10.29
P2
D10.35
P2
D10.37