Table of Contents
Advertisement
4
Roll-Over Protective Structure (ROPS)
FRONT FENDER FLARE INSTALLATION
1.
Position the front fender flare to the vehicle, and secure the flare to the upper frame support using the three
hex-head screws. Tighten hardware to 55 in-lb (6.2 N·m).
2.
Secure the fender flare to the front floorboard using three hex-head screws. Make sure that the floor mat
is captured underneath the fender flare.
3.
Tighten the hardware at the floorboard to 55 in-lb (6.2 N·m).
4.
Reinstall front fascia. See Front Fascia Installation on page 4-4.
5.
Reinstall side cowl panel (fender). See Side Cowl Panel (Fender) Installation on page 4-5.
6.
Reinstall center cowl panel. See Center Cowl Panel Installation on page 4-4.
7.
Replace, lower and secure hood. See Hood Installation on page 4-4.
ROLL-OVER PROTECTIVE STRUCTURE (ROPS)
See General Warnings, Section 1, Page 1-2.
The vehicle is equipped with a certified Roll-over Protective Structure. See following WARNING.
WARNING
• Do not modify the ROPS or operate the vehicle with the ROPS removed. Doing so will void the
certification and could result in property damage, personal injury, or death.
• Do not operate the vehicle if the ROPS is damaged. If the ROPS is damaged, replace the structure.
Do not attempt repair.
Page 4-6
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
BODY AND TRIM
Advertisement
Table of Contents
Troubleshooting
