Choke Cable - Club Car Carryall 295 2014 Maintenance And Service Manual

GASOLINE ENGINE, MUFFLER, FUEL SYSTEM,
AND CLUTCHES
2362
Figure 15-14 Accelerator Cable at Pedal (Z-Shaped Cable
End and Anchor)
Accelerator Cable Installation
NOTE: When the accelerator cable is replaced, the high-speed RPM must be adjusted. See High-Speed RPM
Adjustment on page 15-25.
1. Installation is reverse of removal procedure.
2. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.

CHOKE CABLE

Choke Cable Removal
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Remove seat(s).
3. Remove the center seat plate (bucket seat vehicles only).
4. Remove the engine top cover.
5. Remove the choke cable return spring (1) from the hook on the choke lever (Figure 15-16, Page 15-22).
6. Remove the Z-shaped cable end (2) from the choke lever on the carburetor.
7. Remove the engine front cover (4) (Figure 15-17, Page 15-22).
8. Remove the cable sheath strain relief (3) from the engine front cover (Figure 15-17, Page 15-22).
9. Raise the hood.
10. Compress the choke ferrule tines on the back side of the instrument panel. Pull the cable up from the engine
compartment and remove the cable. See following NOTE.
NOTE: Tie a heavy nylon cord to the cable end before removing the cable. When removing the cable, allow the
cord to travel from the engine compartment up through the instrument panel hole. Use the cord to route
the cable during installation.
2160
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
Engine Control Linkages
Figure 15-15 Accelerator Cable at Engine
15
Page 15-21