Table of Contents
Advertisement
10
Hydraulic System – IntelliTach Vehicle
HYDRAULIC SYSTEM – INTELLITACH VEHICLE
WARNING
• Diesel fuel or hydraulic fluid under pressure can penetrate skin or eyes, causing serious injury or
death. Fluid leaks under pressure may not be visible. Use a piece of cardboard or wood to find leaks.
Do not use your bare hand. Wear safety goggles. If fluid enters skin or eyes, get immediate medical
attention from a physician familiar with this injury.
256
Figure 10-21 Joystick
Inspect the hydraulic fluid level daily.
Use only recommended fluid in the hydraulic system. See Intellitach Specifications, Section 2, Page 2-4.
1.
Lift the cargo box.
2.
Turn the start key to the ON position but DO NOT start the engine.
3.
Press the joystick ON/OFF switch to ON.
4.
Move the joystick (1) back and raise the attachment arm fully (Figure 10-21, Page 10-18).
5.
Move the joystick (1) to the right and tilt the attachment interface fully in.
6.
Press the auxiliary hydraulic rocker switch (2) so that the cylinders are retracted. (If equipped with auxiliary
hydraulics).
7.
Turn the key to the OFF position.
8.
The hydraulic oil level must be between the Maximum Fluid Level and the Minimum Fluid Level lines on the
hydraulic tank (Figure 10-22, Page 10-18).
9.
If hydraulic oil must be added, thoroughly clean the area around the fill cap. Remove the fill cap and add hydraulic
fluid until it is between the Maximum Fluid Level and the Minimum Fluid Level lines.
Page 10-18
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
266
Figure 10-22 Hydraulic Fluid Tank
PERIODIC MAINTENANCE
Advertisement
Table of Contents
Troubleshooting
