Oil Filter Hoses - Club Car Carryall 295 2014 Maintenance And Service Manual

GASOLINE ENGINE, MUFFLER, FUEL SYSTEM,
AND CLUTCHES
20. Install the engine top cover (1) and tighten the four bolts to 35 in-lb (4 N·m).
21. Install the seat frame and lower rear ROPS (Roll Over Protection Structure) bars. See Seat Support Installation
on page 4-10 and ROPS Installation on page 4-8.
22. Install the upper ROPS frame. See ROPS Installation, Section 4, Page 4-8.
23. Install the cargo bed. See Cargo Bed Installation, Section 4, Page 4-12.
24. Add engine oil. See Engine Oil on page 10-10.
25. Check the engine oil level. See Engine Oil Level Check on page 10-11.
26. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
27. Adjust the engine RPM setting. See Engine RPM Adjustment on page 15-24.
28. Install the center seat plate (bucket seat vehicles only).
29. Install seat(s).
30. Test-drive the vehicle to ensure all systems are functional and adjusted correctly.

OIL FILTER HOSES

Oil Filter Hose Removal
1. Drain the engine oil. See Engine Oil on page 10-10.
2. Place a pan under the oil filter hose connections on the engine. See following NOTE.
NOTE: It's best to disconnect the engine hoses first when removing to allow oil to drain from hoses and engine
hose ports.
3. Loosen the clamps on the oil hoses at the engine ports and slide them from the engine port nozzles.
4. Loosen the clamps on the oil hoses at the filter ports and slide them from the filter port nozzles.
13
12
2152
Figure 15-3 Oil Filter Hose Routing
Oil Filter Hose Installation
1. Replace the oil hoses with OEM hoses (Figure 15-3, Page 15-5). See following NOTE.
NOTE: Both oil hoses are molded parts. Do not replace with standard cut-to-length hose. Replace with OEM hoses.
2. Secure the hoses to the port nozzles with clamps. See following NOTE.
14
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
15
Gasoline Engine
Page 15-5