Club Car Carryall 295 2014 Maintenance And Service Manual page 203

TROUBLESHOOTING AND ELECTRICAL
SYSTEM: DIESEL VEHICLES
WARNING
• Hot! Do not touch hot surfaces or boiling water. Contact with hot surfaces or boiling water will result
in severe burns. Allow hot surfaces to cool adequately before touching them.
6.8. The multimeter should indicate continuity between the housing and the white wire when the thermostat
switch is submerged in boiling water. If the multimeter does not indicate continuity, the thermostat switch
has failed and must be replaced. Discard the failed thermostat switch and install a new one. See
Thermostat Switch Installation on page 14-18.
6.9. Turn off the stove. See following WARNING.
WARNING
• Allow surfaces to cool adequately before touching them.
2116
Figure 12-17 Fan Thermostat Switch Test Setup
TEST PROCEDURE 11 – Fan Motor
See General Warnings, Section 1, Page 1-2.
The fan relay activates the radiator fan when the engine coolant reaches a temperature range of 187 °F to 198 °F
(86 °C to 92 °C) and closes the fan thermostat switch.
Fan Motor
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Disconnect the two-pin connector from the thermostat switch (Figure 12-19, Page 12-24) and install a jumper
wire between the frame and the 18-gauge yellow/black wire in the connector.
3. With the Forward/Reverse handle still in the NEUTRAL position, turn the key switch to the ON position. The fan
motor should run. If not, test voltage to fan motor.
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
12
Test Procedures
Page 12-23