Reservoir - Club Car Carryall 295 2014 Maintenance And Service Manual

HYDRAULIC ATTACHMENT SYSTEM
8. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
9. Refill and prime system. See Priming the Pump, Section 19, Page 19-47.

RESERVOIR

Reservoir Removal
1. Remove pump assembly. See Pump Assembly Removal on page 19-43.
2. Lift pump assembly and place it, motor end up, into drain pan. Remove filler cap to drain most of the fluid into pan.
3. Clean and inspect filler cap. Replace cap if damaged or unable to clean.
4. Loosen band clamp and remove reservoir (Figure 19-91, Page 19-45).
2307
Figure 19-91 Loosen Band Clamp
Reservoir Installation
1. Drain remaining fluid and wipe or flush reservoir clean.
2. Clean or replace suction tube filter (Figure 19-92, Page 19-45).
3. Wipe/rinse the pump clean.
4. Clean and inspect reservoir o-ring. Replace if necessary.
5. Lubricate o-ring with new fluid and install reservoir, being careful not to pinch or deform the o-ring. Tighten
clamp to 57 in-lb (6.3 N·m).
6. Install pump assembly. See Pump Assembly Installation on page 19-44.
2308
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
Hydraulic Pump Assembly
Figure 19-92 Suction Tube Filter
19
Page 19-45