Rear Hub Installation - Club Car Carryall 295 2014 Maintenance And Service Manual

WHEELS, TIRES AND HUBS
WARNING
• Strain on the brake hose or the brake hose fittings can result in damage to the line or fittings and
cause a leak in the hydraulic system, diminished brake performance, or brake failure.
• If at any point in this procedure the hydraulic system is opened, the brakes must be bled after the
correct reinstallation of the brake components. Failure to bleed the brakes could result in decreased
braking performance due to air being trapped in the hydraulic system. Use only DOT 5 brake fluid. See
Bleeding the Hydraulic Brake System on page 6-15.
9. Remove brake disc from hub.
10. Remove axle nut (3) and large flat washer (4) and pull hub (5) off axle shaft. See following NOTE.
NOTE: If the hub (5) does not slide easily from the axle shaft, use a two or four-jaw wheel puller to remove the
hub (Figure 8-8, Page 8-7).
4
3
1
2560
Figure 8-7 Rear Hub Exploded View

REAR HUB INSTALLATION

1. Clean the spline and threaded portion of the axle shaft.
2. Apply anti-seize compound to both the axle shaft splines and hub (5) splines. See following CAUTION.
CAUTION
• Do not allow anti-seize compound to contact the brake disc or pads.
3. Slide hub (5) onto axle shaft (Figure 8-7, Page 8-7). See following NOTE.
NOTE: Ensure hub is positioned to slide into the bearing and seal assembly.
4. Install the large flat washer (4) onto the threaded portion of the axle.
5. Install axle nut (3) and advance the nut to the large flat washer.
5
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
2561
Figure 8-8 Puller Removing Rear Hub (If Necessary)
8
Rear Hubs
Page 8-7