Front Coil-Over Shock Absorber Installation - Club Car Carryall 295 2014 Maintenance And Service Manual

STEERING AND FRONT SUSPENSION

FRONT COIL-OVER SHOCK ABSORBER INSTALLATION

NOTE: The standard-duty front coil-over springs and shocks are painted black. Heavy-duty front coil-over springs and
shocks have shock housings painted black and springs painted silver.
When front shock absorbers are installed, ensure both shock absorbers have identical part numbers.
1. Install the top of the shock mount on the vehicle frame with a bolt and flange-head locknut. Tighten the hardware
to 62 ft-lb (84 N·m) (Figure 7-46, Page 7-24). See previous NOTES.
2. Install the bottom of the shock mount on the upper A-arm with a new flange-head bolt. Tighten the hardware to 62
ft-lb (84 N·m) (Figure 7-45, Page 7-24).
3. Remove the floor jack.
4. Install the front tire and wheel. Finger-tighten the lug nuts.
5. Raise the vehicle, and remove the jack stands.
6. Tighten the lug nuts to 87 ft-lb (118 N·m).
7. Repeat steps 1 through 6 for the remaining shock absorber.
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
Front Suspension Components
7
Page 7-25