Seat Support Removal; Seat Support Installation; Seat Belts; Bench Seat Belt Removal - Club Car Carryall 295 2014 Maintenance And Service Manual

4

Seat Belts

SEAT SUPPORT REMOVAL

1. Remove the bolts (9), washers (10 and 11), and flanged locknuts (12) from the seat support (7) and engine cover
plate (Figure 4-1, Page 4-7).
2. Remove the seat support.

SEAT SUPPORT INSTALLATION

1. Install the seat support (7) (Figure 4-1, Page 4-7).
2. Secure the seat support to the seat side plates with bolts (9), washers (10 and 11), and flanged locknuts (12).
Tighten the hardware to 37 ft-lb (50 N·m).
SEAT BELTS
See General Warnings, Section 1, Page 1-2.
CAUTION
• Be careful not to damage the safety belt webbing or hardware.
• Inspect the safety belt system periodically. Check for cuts, fraying, and loose parts. Replace damaged
parts immediately. Do not disassemble or modify the system.
• Keep safety belts clean and dry. If cleaning is necessary, use a solution of mild soap and lukewarm
water. Do not use bleach, dye, or abrasive cleaners as they may severely weaken the safety belts.
• Do not insert coins, clips, etc. into the safety belt buckle. Foreign objects may interfere with the
buckle locking mechanism.
• If the safety belt does not function normally, contact your dealer/distributor or trained technician
immediately. Do not occupy the seat until the safety belt is repaired.

BENCH SEAT BELT REMOVAL

1. Remove the flange bolt and nut from the base of the coiled seat belt assembly (outside location) (Figure 4-2,
Page 4-11).
2. Remove the coiled seat belt assembly.
3. Remove the nut, small washer and two large washers from the seat belt buckle assembly (center location)
(Figure 4-3, Page 4-11).
4. Remove the shoulder bolt, spring washer and seat belt buckle assembly.
Page 4-10 2014 Carryall 295/XRT 1550 Maintenance and Service Manual
BODY AND TRIM