Clutch Cover - Club Car Carryall 295 2014 Maintenance And Service Manual

15
Clutches
Driven Clutch Installation
1. Install the driven clutch assembly on the transmission splined shaft.
2. Install the mounting washer and new retaining bolt. Tighten retaining bolt to 39 ft-lb (53 N·m).
3. Install the drive belt as instructed. See Drive Belt Installation on page 15-29.
4. Install the clutch outer cover and tighten the screws to 72 in-lb (8 N·m).
5. Install the top air filter hose on the filter canister. See following NOTE.
NOTE: Ensure the hose contacts the canister and the clamp is installed tightly between the port bead and canister.
6. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
7. Drive the vehicle and check for proper operation.

CLUTCH COVER

Clutch Outer Cover Removal
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Remove the top air filter hose from the filter canister.
3. Remove the self-threading screws and remove the clutch outer cover. See following WARNING.
WARNING
• Clutch outer cover must be installed before returning the vehicle to normal operation. If the engine is
operated with the clutch outer cover removed, keep hands away from the clutches and belt. Failure to
heed this warning could result in severe personal injury.
Clutch Outer Cover Installation
1. Align the mounting holes in the clutch cover with the mounting holes in the inner cover.
2. Install the screws and tighten the hardware to 72 in-lb (8 N·m).
3. Install the top air filter hose on the filter canister.
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1,
Page 1-4. See following NOTE.
NOTE: Ensure the hose clamp is tightly installed and positioned between the filter canister and canister port bead.
Clutch Inner Cover Removal
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Remove the outer clutch cover. See Clutch Outer Cover Removal on page 15-36.
3. Remove the drive belt. See Drive Belt Removal on page 15-29.
4. Remove the drive clutch. See Drive Clutch Removal on page 15-30.
5. Remove the driven clutch. See Driven Clutch Removal on page 15-33.
6. Remove the bolts and washers from the clutch inner cover (Figure 15-31, Page 15-37).
7. Remove the clutch inner cover.
Clutch Inner Cover Installation
1. Align the mounting holes in the clutch cover with the transmission and engine bolt holes.
2. Loosely install one bolt and washer in each transmission and engine mounting hole.
3. Finger-tighten the bolts and washers.
Page 15-36 2014 Carryall 295/XRT 1550 Maintenance and Service Manual
GASOLINE ENGINE, MUFFLER, FUEL
SYSTEM, AND CLUTCHES